 Pumpkin Treat Holder
Level: Easy
Materials
CRAFTFOAM GLUE
GEM-TAC EMBELLISHING GLUE
• Craft foam sheets in orange, yellow, green & brown
• Orange acrylic paint
• Two 18mm moveable eyes
• 5/8” black check ribbon, 13 ½” length
• 3/8” green grosgrain ribbon, 10” length
• Black permanent fine tip marker
• Three ½” green buttons
• Two 5/8” green buttons
• Scissors, sponge, ruler
|
| Instructions: |
| 1. |
Print pattern and cut out each section. Trace each onto craft foam as follows: brown for the stem, green for the leaves, yellow for the eyes, nose & mouth, and orange for pumpkin and pocket. |
| 2. |
Using a damp sponge, sponge paint the front and back of the pumpkin and one side of the pocket with the orange paint. Let dry. |
| 3. |
Draw lines around both sides of the pumpkin, pocket, eyes, nose, mouth, leaves & stem with the fine tip marker. |
| 4. |
Glue the pocket to back of the pumpkin leaving the top of the pocket unglued. Following the directions for CRAFTFOAM GLUE, glue on the eyes, nose, mouth, stem & leaves as in the photo. |
| 5. |
Glue on the moveable eyes with GEM-TAC and the 5/8” green buttons at the corners of the mouth and the ½” green buttons on the leaves as in the photo. |
| 6. |
Glue black checked ribbon to the back of the pumpkin and the black buttons onto the ends of the ribbon with GEM-TAC. |
| 7. |
Make a bow with the green ribbon, cutting the ends at an angle and glue bow onto the leaves with GEM-TAC as in photo. |
|
More HALLOWEEN
Craft Project Links:
..Sparkling Spider Treat Holder
..Friendly Ghost Frame
..Halloween Ghost Wreath
..Haunted House Box
..Trick or Treat BOO Container
..Smiling Pumpkin Candy Container
|
BEACON ADHESIVES, Inc., 125 MacQuesten Parkway South, Mount Vernon, NY 10550, Tel: (914) 699-3405
E-mail: Crafts4@BeaconAdhesives.com
Beacon is not responsible for the manner in which our products are used and,
therefore, cannot guarantee results. Beacon's liability is limited to product replacement.
|
